Computational Simulation and 3D Virtual Reality Engineering Tools for Dynamical Modeling and Imaging of Composite Nanomaterials

An adventure at engineering design and modeling is possible with a Virtual Reality Environment (VRE) that uses multiple computer-generated media to let a user experience situations that are temporally and spatially prohibiting. In this paper, an approach to developing some advanced architecture and modeling tools is presented to allow multiple frameworks work together while being shielded from the application program. This architecture is being developed in a framework of workbench interactive tools for next generation nanoparticle-reinforced damping/dynamic systems. Through the use of system, an engineer/programmer can respectively concentrate on tailoring an engineering design concept of novel system and the application software design while using existing databases/software outputs.Comment: Submitted on behalf of TIMA Editions (http://irevues.inist.fr/tima-editions

Detecting unilateral phrenic paralysis by acoustic respiratory analysis

The consequences of phrenic nerve paralysis vary from a considerable reduction in respiratory function to an apparently normal state. Acoustic analysis of lung sound intensity (LSI) could be an indirect non-invasive measurement of respiratory muscle function, comparing activity on the two sides of the thoracic cage. Lung sounds and airflow were recorded in ten males with unilateral phrenic paralysis and ten healthy subjects (5 men/5 women), during progressive increasing airflow maneuvers. Subjects were in sitting position and two acoustic sensors were placed on their back, on the left and right sides. LSI was determined from 1.2 to 2.4 L/s between 70 and 2000 Hz. LSI was significantly greater on the normal (19.3±4.0 dB) than the affected (5.7±3.5 dB) side in all patients (p = 0.0002), differences ranging from 9.9 to 21.3 dB (13.5±3.5 dB). In the healthy subjects, the LSI was similar on both left (15.1±6.3 dB) and right (17.4±5.7 dB) sides (p = 0.2730), differences ranging from 0.4 to 4.6 dB (2.3±1.6 dB). There was a positive linear relationship between the LSI and the airflow, with clear differences between the slope of patients (about 5 dB/L/s) and healthy subjects (about 10 dB/L/s). Furthermore, the LSI from the affected side of patients was close to the background noise level, at low airflows. As the airflow increases, the LSI from the affected side did also increase, but never reached the levels seen in healthy subjects. Moreover, the difference in LSI between healthy and paralyzed sides was higher in patients with lower FEV1 (%). The acoustic analysis of LSI is a relevant non-invasive technique to assess respiratory function. This method could reinforce the reliability of the diagnosis of unilateral phrenic paralysis, as well as the monitoring of these patients.Peer ReviewedPostprint (published version

Электроснабжение установки перекачки нефти п. Пионерный ОАО «Томскнефть»

РЕФЕРАТ Выпускная квалификационная работа 149 с., 23 рис., 32 табл., 29 источников, 6 прил. Ключевые слова: нефтепровод, насос, электрооборудование, схема электроснабжения, линия, сеть, электроприемник, нагрузка, оборудование, защита, ток, напряжение, мощность. Объектом исследования является электрическая часть УПН п. Пионерный ОАО «Томскенефть». Цель работы – проектирование схемы электроснабжения предприятия, выбор оборудования. В процессе исследования проводился сбор исходных данных в ходе производственной практики на объекте исследования. В результате была спроектирована схема электроснабжения от подстанции энергосистемы, до конечного электроприемника. Были выбраны кабели и провода, коммутационное оборудование, были сделаны необходимые проверки. Также результатом работы сталESSAY Final qualifying work 149 p., 23 fig., 32 tab., 29 sources, 6 adj. Keywords: oil, pump, electrical equipment, power supply circuit, line, network, power-consuming equipment, load equipment, protection, current, voltage, power. The object of research is the electrical part of UPN claim. Pionerny of "Tomskeneft". The purpose of work - designing enterprise power scheme, the choice of equipment. The study was conducted to collect baseline data in the course of practical training on the subject of the study. As a result, power supply circuit has been designed from the substation grid, appliance, to the end. Were selected cables and wires, switching equipment, the necessary checks have been made. It is also the result of the work became an economic calculation of capital costs for the con